Gadgets

NEW Flex Connector

Every amateur and pro model train technician recognises the problem of lots of wires in the model to connect a variety of functions. Some wires soldered together, protected from shorts with a bit of tape around it. Train-O-Matic comes to the rescue with this incredibly fine and handy Flex Connector.

The strong 6 pin flat cable is only 0.14 mm thin and slides in the slots of either a flat or corner connector. These connectors have 6 solder pads, so it is very easy to connect the wires or component contacts. Nice, reliable and clean.

The FLAT CONNECTOR has a tab which, when pushed down, will lock the flex cable in place. The CORNER CONNECTOR holds the flex cable in its slot with friction. Both will guarantee a reliable connection.

02020302 Flex Connector 6PH

FLEX CABLE + 2x FLAT CONNECTORS

Size: 48.5 x 5.5 x 1.8 mm

02020303 Flex Connector 6PV

FLEX CABLE + 2x CORNER CONNECTORS

Size: 37.2 x 5.5 x 9.2 mm

02020304 Flex Connector 6PHV

FLEX CABLE + 1x CORNER + 1x FLAT CONNECTOR

Size: 41.2 x 5.5 x 9.2 mm

Buy our products from one of our partners

02020106 Next18 Male Adapter Board

by Train-O-Matic

Size 9 x 9.6 mm

Pack of 5

02020107 Next18 Female Adapter Board Type 1

by Train-O-Matic

Size: 9 x 9.6 mm

Pack of 5

Next18 connectors

02020108 Next18 Female Adapter Board Type 2

by Train-O-Matic

Size: 9 x 9.8 mm

Pack of 5

Motor filter (pack of 5)

02020301 Motor Filter

by Train-O-Matic

When converting an analog locomotive to digital (using a decoder), the manufacturer installed capacitors must be removed, because they will affect the decoder functionality. This concerns mostly the BEMF (Back ElectoMotive Force) reading.

The Train-O-Matic motor filter will clean the noise between the motor and decoder and improve the communication between decoder and motor for a smoother ride.

Only for DCC systems.

Buy our products from one of our partners

•